Should i install motherboard first

The motherboard will be inside an anti-static bag and resting on top of anti-static foam. Slide the motherboard out of the bag, but leave it attached to the foam for now. Place the motherboard and foam on top of the anti-static bag, and take out the metal blanking plate. The blanking plate fits into the case and gives you access only to the ports that your motherboard has. However, some motherboard manufacturers use generic blanking plates that fit their entire range of boards.

The easiest way to see is to hold the blanking plate up to the motherboard until the cutouts match the ports on your board. The blanking plate should be pushed against the motherboard with the ridge pointing out, so any text is readable.

Make a note of any ports that are covered. If you need to remove any parts of the blanking plate, you should do that now. First, you may have to remove a bit of metal, in a similar way to the metal blanking plates on your case. These should be rocked gently out until the metal snaps. Second, some ports may be covered by a flap.

In this case, the flap should be bent inwards towards where the motherboard will be. From the inside of the case, you need to take the blanking plate and push it into the gap at the rear of the case.

The ridge around the outside of the plate should clip into the hole. It should, however, clip into place and remain stable without any support. Components 4 Dec 20, Post thread. Question i get a oemid error when i try to update motherboard Started by aryatikku Yesterday at PM Replies: Question Super giving me worse frames than a ? Started by Small-Change Oct 7, Replies: Graphics Cards. Yesterday at PM Replies: 0. Question What does this mean?? News Comments.

Latest posts. Question PC won't boot after turning on secure boot Latest: Jollyrobo 15 minutes ago. Question Some artifacts appear on the screen in safe mode Latest: Colif 24 minutes ago. Question Ram Bsod, help Latest: Colif 31 minutes ago. Moderators online. Tom's Hardware is part of Future plc, an international media group and leading digital publisher. Visit our corporate site. All rights reserved. England and Wales company registration number Question need asus za installer disc or copy.

Yesterday at PM. Oct 31, An improperly seated CPU can cause all sorts of problems, from overheating to a nonbootable system. A few things can go wrong, however. If the socket has any foreign matter that could prevent the processor from seating properly, significant problems could occur. Before placing the processor into its socket, give the socket a thorough physical inspection without touching any contacts and make certain that the socket has nothing in it that could interfere with the processor.

When handling an AMD CPU, grasp it from the sides only, inspect its underside to confirm that no pins are bent, and use minimal force as you insert it into the socket. In fact, an AMD processor should just drop into its socket, provided that all of the pins are aligned properly. A little dab will do. Installing too much or too little thermal interface material is a common rookie mistake.

When new system builders attempt to install CPU coolers or heatsinks, they tend to make three mistakes: They use too much or too little interface material, they seat the cooler improperly, or they point the cooling fan in the wrong direction. TIMs help facilitate heat transfer from the chip into the base of the heatsink.

Using too much or too little TIM can hinder the heat transfer, however. A dab a little larger than a BB but smaller than a pea will do. In addition, it is critical to confirm that the cooler or heatsink is seated properly and making good contact with the CPU. If a CPU cooler is even slightly off-kilter, the processor is likely to overheat and take damage. Pay special attention to the design of your particular case, though, as some rear-mounted fans are actually intakes. Some of the most common issues that new system builders face relate to the brass standoffs included with most cases.

Brass is a relatively soft metal, so stripping the threads on the standoffs is somewhat easy. Be sure to use only enough force to keep them snug against the motherboard tray; finger-tightening is usually sufficient.